Altigen MAXCS 7.5 Softswitch Deployment Guide Manual do Utilizador descarregar pdf (Página 29)

MAXCS 7.5 All-Software Solution Deployment Guide Page 29 of 37

Step 16: Add a New SIP Trunk Profile

We recommend that you add a new SIP Trunk profile.

1. Open the SIP Trunk Configuration panel:

a. In MAXCS Administrator, open Trunk view.

b. Double-click an unconfigured SIP Trunk.

c. In the Trunk Configuration panel, click Trunk Properties.

d. In the next dialog box, click SIP Trunk Configuration.

e. Click SIP Trunk Profile.

2. Create a new SIP Trunk profile, specifying the following parameters.

• Set the SIP Protocol Field to FROM Header.

• Select Carrier can only accept assigned numbers as Calling Number.

• Enter the range of DID numbers that you want to assign to this trunk in the Calling Number can

be accepted by the Carrier box. These must be valid DIDs that are on the trunk; each entry

must be 10 digits.

• For the Use this Calling Number if the Carrier cannot accept configured numbers field, enter

the main phone number. The phone number that you enter must be included among the

Calling Number can be accepted by the Carrier entries.

• Select Send Caller Name. (Do NOT select Enable Standard Record-Route Header.)

• Set Incoming DID Number field to To Header.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Sem comentários

Altigen MAXCS 7.5 Softswitch Deployment Guide Manual do Utilizador Página 29